TPS

To get the throttlebody in to the new millennium a Throttle Position Sensor, TPS was required. I had a Buell throttle body with a TPS in the shop already so why not use that one. First I made a bracket to fit the TPS to the throttlebody. Then it was time to adapt the shaft to fit the TPS.
A hole had to be drilled dead center of the shaft to accept a small pin to turn the TPS. And finally a new connector was attached to the TPS.

The bracket

TPS test fitted

The drilled shaft

Dead center

Not to shabby consider I did it with a low buck asian drillpress.

New connector on the TPS